Quantum Integrated Technical Solutions

• Identification of De-energized Cables
• On single-phase and three-phase cables
• Detection of the Amplitude and Polarity of the active signal

• Internal GPS and/or
• Fault detection functionality and/or
• the digitization app GridGIS Map Creator

• De-energised cable identifier
• Single-phase and three-phase cables
• Signal injection by Direct connection or Induction clamp
• Cable length > 50 km (direct connection)
• Induction signal amplitude and polarity detection
• Identification sound alert
• Operation time > 24 h (level 2)
• Rechargeable battery on the transmitter (CI-DE Tx)

• Positive cable identification without de-energising the network
• Works on LOW VOLTAGE distribution cables up to 250 V (50-60 Hz)
• Sensor Rogowski: identifies cables by placing the sensor around the cable
• U” sensor: identifies conductors by touching the cable
• Single-phase and three-phase cables
• Fast identification, achieved in seconds
• Simple operation due to automatic synchronisation between transmitter and receiver

• Safely cable identification
• De-energised cable identification
• LV live cableidentification
• MV energized cable identification
• Single-phase and three-phase cables
• Signal injection by Direct connection or Induction clamp
• Cable length > 50 km (direct connection)
• Identification sound alert (CI-Rx)
• Signal amplitude and polarity detection
• Operation time > 24 h (level 2)
• Rechargeable battery on the transmitter (CI-Tx)

• Positive cable identification without de-energising the network
• Works on LOW VOLTAGE distribution cables up to 250 V (50-60 Hz)
• Sensor Rogowski: identifies cables by placing the sensor around the cable
• U” sensor: identifies conductors by touching the cable
• Single-phase and three-phase cables
• Fast identification, achieved in seconds
• Simple operation due to automatic synchronisation between transmitter and receiver

• Phase identification in cables with both ends in short-circuit
• Identification of phases in cut cables without short-circuit
• Join two three-phase lines phase to phase
• Identify any De-energized cable
• Single-phase and multi-phase cables
• Signal injection:
  • Direct connection
  • Induced with induction clamp
• Max. cable length > 50 km
• Visual and acoustic indication
• Rechargeable battery in transmitter. Operation time > 12h (continuous injection with inductive clamps).
• It doesn’t require calibration before using it (calibrated at factory)

The Ariadna CI is an advanced digital tool, with a simple and effective usage procedure. It enables electrical cables to be identified, energised or not, between a set of conductors in places such as: manholes, ditches, enclosures, etc.

In electrical maintenance works, in order to cope with safety standards, it becomes necessary to identify de-energized cables unambiguously prior to its manipulation.

In electrical maintenance works, in order to cope with safety standards, it becomes necessary to identify de-energized cables unambiguously prior to its manipulation.

•  energized MV cables
• energized LV cables
• de-energized MV and LV cables

• Direct connection to cables
• Signal induction through toroidal clamp (optional)

• Single phase conductors (shielded or unshielded)
• Three phase or 3 phase + neutral conductor
• Detects active signal’s Amplitude and Polarity
• Maximum cable length > 10km (direct connection)
• Rechargeable Li-ion battery on transmitter (CI-TX):
• >24h at level 2 (up to 4) of transmission power